When to Replace the PICO Rotor
If your PICO pump has become noisy, sluggish, or has stopped moving water entirely, the rotor is often the culprit. Over time, the magnetic impeller can wear, collect debris, or become misaligned. Replacing just the rotor—rather than the whole pump—is a cost-effective fix that restores flow without a full unit swap.
The Ferplast PICO Rotor is a dedicated spare part designed for several PICO pump models. Before ordering, check which size fits your unit to avoid a mismatch.
PICO Rotor Compatibility at a Glance
- PICO Rotor: Available in the 250‑600 size for standard PICO units. This is the most common size for small to medium PICO pumps. If your pump is a standard PICO model, start here.

PICO Rotor - PICO Rotor: Fits the 1150 model, ensuring seamless integration. The 1150 variant is a direct replacement for that specific pump; no adapters needed.
- PICO Rotor: Compatible with the 600.115 specification. If your pump is labelled 600.115, this rotor matches exactly.
- PICO Rotor: Designed for the 1000 size rotor replacement. For larger PICO 1000 pumps, this variant ensures proper fit and performance.
- PICO Rotor: Matches the PICO 400‑PICO EVOMAG 650 configuration. Covers both the PICO 400 and the EVOMAG 650 models, so one rotor works for two pump families.
How to Identify Your Pump Model
Before buying a replacement, locate the model number on your pump housing. It is usually printed on a sticker or moulded into the plastic. Common markings include 'PICO 250-600', 'PICO 1150', '600.115', 'PICO 1000', or 'PICO 400' / 'PICO EVOMAG 650'. Match that label to the rotor variant listed above.
If the label is worn or missing, measure the rotor housing diameter and compare to the available sizes. The 250‑600 variant fits the most common small pumps; the 1000 variant is physically larger.
Replacing the Rotor: Step-by-Step
Replacement is straightforward and requires no special tools. Follow these steps with the pump unplugged.
- 1. Disconnect and disassemble: Unplug the pump from the mains. Remove the pump from the aquarium or filter housing. Take off the front cover or intake cage to access the rotor chamber.
- 2. Remove the old rotor: Gently pull the rotor assembly out. Note the orientation of the ceramic shaft and rubber stopper if present. Inspect the shaft for cracks or wear.
- 3. Clean the chamber: Rinse the rotor chamber with warm water to remove any debris or algae. Do not use soap or abrasive cleaners. Check that the ceramic shaft is clean and smooth.
- 4. Install the new rotor: Insert the new PICO Rotor into the chamber, ensuring the impeller spins freely. Reattach the front cover securely.
- 5. Test before full install: Plug the pump in briefly (in a bucket of water or submerged in the tank) to confirm smooth operation and water flow. If it rattles, the rotor may not be seated correctly or the shaft may be dirty.
Maintenance Tips to Extend Rotor Life
Regular cleaning of your pump and rotor can prevent premature wear. Every 2-4 weeks, disassemble the pump and rinse the rotor and chamber to remove buildup. Avoid letting the pump run dry, as this can damage the rotor bearings.
If you notice vibration or reduced flow even with a clean rotor, the ceramic shaft may be worn. The supplied information does not cover shaft replacement, so consider replacing the entire pump if the shaft is damaged.


